Bicycle Turn Signals LED Laser Bike Lights Wireless Rear Indicator
This is for the Cyclist!
Be Seen...Be Safe!
This innovative bicycle laser with signal indicator system is so simple it's brilliant! Consisting of two parts - the wireless remote control unit which fits onto the handlebars and the light unit which attaches to the seat post.
The signalling system allows you to give a clear indication of your intention to turn either left or right. And if you get a problem - then it even has a hazard warning flashing lights. It also comes with an ultra brightness laser to warn other road users. Laser safety lights emits two parallel laser lines on either side of your bicycle, from a virtual lane along with bicycle moving on the road.
Both units are battery operated and no wiring is needed. The controller has four buttons - left, right, LED and LD (laser) with blue lights which show what you have pressed and can be sited on either the left or right hand side of the handlebars. You can also activate the hazard warning light by pressing either the left or right button for three seconds.The light unit attaches to the seat post and has two large signal indicators to indicate left or right. Both set of the signal indicators lights up when the hazard button is pressed.
Both units simply slide out of the brackets so you can take them with you when you leave your bicycle parked. The control unit is supplied with a replaceable cell battery. The indicator unit requires 2 alkaline or rechargeable AAA batteries - not supplied.
Laser safety light emits two parallel laser lines on either side of your bicycle, which forms a virtual lane along with the moving of the bicycle on the road. Six LED flash lights and two laser lines enhances your visibility to motorists and other road users close to you. The LED laser lines also serves as an additional measure to alert approaching motorists to maintain a safe distance enhancing your night cycling safely considerably.
Innovative Bicycle Wireless Signalling System
Easy To Attach/Detach
Light Unit Attaches To Seat Post - 25.4mm to 32mm
Operating Unit Attaches To The Handlebars
5 Signals - Left, Right, LED Warning Light, LD laser Light and Hazard Warning Lights
LED Design Offers 270 Degrees Visibility ~ which matches German standards
Uses 2 "AAA" Batteries (Not Included) (Light Unit only)
Waterproof Level Of Casing Meets IPx2 Specification
10 Hours Run Time Per Battery Set (Flash Mode)
Laser Diode Lifespan: 5000 Hours
6 Super Bright LED, 2 Red Laser Line
Micro Laser Product design - Meets The Criterion Of The Laser Safety Standards
Waterproof and Shockproof Function
Remote Control Bike Laser with Signal Indicators
Bicycle Mounting Ring
Wireless Remote Control Range: 5 Meters
Laser type: Visible Light
Continuous Output, Meets Class IIIA Laser Safety Standards
Environmental Protection Material
This product comes with a warning:
Never point a laser beam at a person or animal.
Do not allow children to operate the product alone.
To avoid eye damage, do not ever look directly into a laser beam.
Avoid staring at LED lights too closely.
This product is rainproof only, do not immerse in water.
Check out the independent review by a customer of ours on You Tube, we took issue with the price quoted which is incorrectly quoted and has been disputed, but overall a good product review - take a look: https://www.youtube.com/watch?v=wKsJxDumFLQ&list=UUwrdNAo5jrYEbijHPh_GlGA&index=6
Pimp-My-Bike Retail General Warranty for Bicycle Signalling System
Pimp-My-Bike Retail provides the Bicycle Signalling System with a 12 month return period commencing on the delivery date. During this period, Pimp-My-Bike Retail warrants that the device will be free of material defects that prevent its normal operation. You are entitled to one (1) year limited warranty service according to the terms and conditions in the limited warranty statement within the warranty period in the UK or locality where the Bicycle Signalling System is marketed.
The warranty period starts on the date of purchase. Your dated sales receipt, which shows the date of purchase, is your proof of purchase date. You may be required to provide the date of purchase as a condition of receiving warranty service.
Pimp-My-Bike Retail shall not be liable for any damages or defects to the Bicycle Signalling System caused by improper use or by accident, malicious damage, hazard, excess humidity, liquid ingress, electrical stress, or other environmental conditions not commonly found in a normal safe working environment. Please note that each device is fitted with a liquid sensor and its reaction will serve as proof of liquid ingress having occurred.
Your Bicycle Signalling System is warranted to be free from defects in material and workmanship under the normal use during the limited warranty period except the scratch on the appearance, plastics accessories and rubber pads.
The defective material of your returned Bicycle Signalling System will be repaired or replaced with the new, or equivalent to new, spared material in the provided warranty service. A repaired or replaced Bicycle Signalling System will be warranted for the unexpected portion of the original Bicycle Signalling System's warranty.
Pimp-My-Bike Retail shall not be liable if the defect arises because you have failed to follow the manufacturer's written instructions as to storage, installation, commissioning, use or maintenance of the Bicycle Signalling System or if you alter or attempt to repair the relevant Bicycle Signalling System without the written consent of Pimp-My-Bike Retail.
Pimp-My-Bike Retail's warranty does not extend to cables, accessories, plugs, rubber pads, batteries, plastics or power supply units. It is your responsibility to return the faulty Bicycle Signalling System back to us. You are expected to reuse original supply packaging for product examination and ensure safe transport. Incorrectly packaged returns may be processed as a chargeable repair.
Pimp-My-Bike Retail will, in its discretion, either repair or replace the faulty Bicycle Signalling System within 90 days of the receipt of the Bicycle Signalling System. Pimp-My-Bike Retail will return the Bicycle Signalling System to you at our cost.
Pimp-My-Bike Retail advises you to carefully check the Bicycle Signalling System before dispatch to ensure it is defective. Bicycle Signalling System returned which is not found to be defective, or has been damaged or misused by you will be returned to you and may be invoiced for the cost of shipping.
Your Bicycle Signalling System is designed with the latest technology to provide a trouble free operation. Based on your purchase agreement, you are offered with variety technical support options*. Should you think your Bicycle Signalling System needs technical support or repair, please contact Pimp-My-Bike Retail - your local Bicycle Signalling System dealer/authorised service centre for service through the eBay contact us link and your queries will be responded back to.
*Your service programme is only valid in the UK where your Bicycle Signalling System is purchased, and NOT transferable to another country or region.
CYCLISTS ~ please consult "Rules for Cyclists" sections 59 to 82 of the Highway Code.